BHNBD - AERODOL SPRAY PAINT TT-E-489-G BLUE 15095
- MSDS: BHNBD
- Manufacturer: PLASTI KOTE CO INC
- Product Name: AERODOL SPRAY PAINT TT-E-489-G BLUE 15095
- National Stock Number: 8010-00-988-1458
Product Identification
Product ID:AERODOL SPRAY PAINT TT-E-489-G BLUE 15095
MSDS Date:01/08/1987
FSC:8010
NIIN:00-988-1458
MSDS Number: BHNBD
Responsible Party
MEDINA, OH 44256
US
Emergency Phone: (216) 725-4511
Info Phone: (216) 725-4511
Cage: HO182
Contractor
Telephone: 330-725-4511
Cage: 07708
Ingredients
NO INGREDIENT FOR THIS FORMULATION_INGREDIENT
Hazards
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO
Health Hazards Acute and Chronic:INHAL: NASAL & RESPIR IRRI, DIZZ,
WEAK, FATIGUE, NAUSEA, HEADACHES, UNCONS, ASPHXIATION. METHYLENE
CHLORIDE-LOSS OF CONS & DEATH AS LOW AS 10,000 PPM NUMBNESS, RAPID
HEART BEAT. EYES: SEV IRRI, RED, T EAR, BLURRED VISION, CONTACTS
SHOULD NOTBE WORN. SKIN: PAINFUL IRRI. SWALLOW: GASTROIN IRRI,
NAUSEA, VOMIT & DIARRHEA.
Explanation of Carcinogenicity:METHYLENE CHLORIDE APPEARS ON ABOVE
AGENCIES LISTS OF SUSPECTED CARCINOGENS.
Effects of Overexposure:SEE ABOVE. PROLONGED OVEREXPOSURE TO SOLVENTS
WITH PERMANENT BRAIN & NERVOUS SYSDAM. SEVERE OVEREXPOSURE IN LAB
ANIMALS HAS ALSO CAUSED LIVER ABNORMALITIES AND DAMAGE TO KIDNEYS,
LUNG & SPLEEN. INTENT MISUSE BY DELIBERATE CONCEN & INHALE
OFCONTENTS MAY BE HARMFUL OR FATAL. ALSO SKIN: IRRITATION,
DEFATTING & DERMATITIS.
Medical Cond Aggravated by Exposure:CAN CAUSE ALLERGIC RESPIRATORY
REACTIONS AND/OR SKIN REACTIONS.
First Aid
First Aid:INHALE: REMOVE TO FRESH AIR. IF BREATH IS DIFF, ADMIN OXYGEN,
IF STIPPED, GIVE CPR & SEEK MED HELP. EYES: FLUSH W/WTR 15 MINS.
WHILE LIFTING LIDS. GET MED ATTNSWALLOWED: DO NOT INDUCE VOMIT
(ASPIRATI ON OF MATERIAL INTO LUNGS CAN CAUSE CHEMPNEUMONITIES, CAN
BE FATAL) KEEP PERSON WARM/QUIET, GET MED ATTN/POISON CONTROL
CENTER. SKIN: WASH W/SOAP & WTR OR VARIOUS HAND CLEANERS. LAUNDER
CLOTHING
Fire Fighting
Flash Point:NR
Lower Limits:1.0
Extinguishing Media:ALCOHOL, FOAM, CO2, DRY CHEMICAL.
Fire Fighting Procedures:WTR SPRAY MAY BE INEFFECT, USE TO COOL CLOSED
CONT TO PREVENT PRESSURE BUILD-UP/AUTO-IGNITE/EXPLOSION. IF WTR
USED FOG NOZZLE PREFER. SELF CONT BREATH APPARATUS
Unusual Fire/Explosion Hazard:CLOSED CONT MAY EXP &/OR AUTOIGNITE WHEN
EXPOSED TO EXTREME HEAT. VAPORS ARE HEAVIER THAN AIR, MAY TRAVEL
ALONG GROUND OR BY VENT & IGNITE AT LOCATIONS DISTANT
Accidental Release
Spill Release Procedures:ELMINATE ALL IGNITION SOURCES. EVACUATE AND
VENT AREA. TURN OFF HEATING/AIR CONDITIONING TO PREVENTVAPOR
CONTAMINATION. ABSORB LIQUID ON PAPER OR VERMICULITE. FLOOR
ABSORBENT OR OTHER ABSORBENT MATERIAL & TRANSFER TO CLOSED
CONTAINER.
Handling
Handling and Storage Precautions:DO NOT STORE IN AREAS ABOVE 120 F. IN
DIRECT SUNLIGHT OR NEAR HEAT OR OPEN FLAMES. DO NOT
PUNCTURE OR INCINERATE.
Other Precautions:NONE.
Exposure Controls
Respiratory Protection:TO AVOID BREATHING VAPORS OR SPRAY MIST, OPEN
WINDOWS & DOORS OR USE OTHER MEANSTO ENSURE FRESH AIR ENTRY DURING
APPLICATION & DRYING. WHERE VAPOR CONCENTRATIONIS GREATER THAN 100
PPM AN ORGANIC VAPOR TYPE RESPIRATOR IS ADVISED.
Ventilation:PROVIDE SUFFICIENT MECH (GENERAL) &/OR LOCAL EXHAUST VENT
TOMAINTAIN EXPOSURE BELOW TLV'S. DO NOT USE IN CONFINED AREA.
Protective Gloves:CHEMICAL RESISTANT (NEOPRENE).
Eye Protection:CHEMICAL SPLASH GOGGLES (OSHA REGULATED)
Other Protective Equipment:SOLVENT RESISTANT BOOTS, APRON, HEADGEAR
AND/OR FACESHIELDS SHOULD BE WORN WHERE SPLASHING IS POSSIBLE.
Work Hygienic Practices:WASH HANDS BEFORE EATING OR USING WASHROOM. AS
WITH ALL CHEMICALS, MINIMIZE PERSONAL CONTACT AND/OR BREATHING OF
VAPORS.
Supplemental Safety and Health
NK.
Chemical Properties
HCC:V3
Boiling Pt:B.P. Text:104-300 F
Melt/Freeze Pt:M.P/F.P Text:1500 E
Vapor Density:> AIR
Spec Gravity:< 1
Evaporation Rate & Reference:>1, PROPELLANT <1
Solubility in Water:SLIGHT TO MODERATE
Appearance and Odor:TYPICAL SOLVENT PAINT
Percent Volatiles by Volume:80-85
Stability
Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS, HEAT, ALKALIES, HOT SURFACES AND REACTIVE
METALS.
Stability Condition to Avoid:HEAT, SPARKS AND OPEN FLAME.
Hazardous Decomposition Products:MAY FORM TOXIC MATERIAL; NITROGEN
COMP, ETC. CARBON DIOXIDE/MONOXIDE, HYDROGEN CHLORIDE, PHOSGENE,
VARIOUS HYDROCARBONS.
Disposal
Waste Disposal Methods:MATERIAL COLLECTED ON ABSORBENT MATERIAL MAY BE
DEPOSITED IN A POSTED TOXIC SUBSTANCE LANDFILL IN ACCORDANCE WITH
LCOAL, STATE AND FEDERAL REGULATIONS.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.